Sagem F@ST 1400W Guide de l'utilisateur télécharger pdf (Page 31)

Troubleshooting 30

SAGEM F@st™ 1400 / 1400W

TROUBLESHOOTING

Absence of ADSL synchronization

Access to the HTTP configurator is impossible

The LINE LED does not come on or is flashing.

• Check that the modem/router is powered up. The PWR LED should be on. If that is not

the case:

- Check that the power pack is properly connected to the mains. If it is connected to a

multiple socket block, check that this is powered up.

- Check that the power pack cable is properly connected to the modem/router.

- Check that the ON/OFF switch (I/0) is in the "I" position.

• Check that the ADSL is properly connected to your telephone socket, to the LINE port of

the modem/router.

• Check that all the ADSL filters are properly connected to each of your telephone sockets.

If the problem persists, consult your Internet Service Provider.

All your telephone installation sockets must be fitted with an ADSL filter.

• Open your usual Web browser.

• In the Address field, type the modem/router’s IP address:

http://192.168.1.1

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 42 43

Pas de commentaire

Sagem F@ST 1400W Guide de l'utilisateur Page 31