Sagem MYV-56 Manuel d'utilisateur télécharger pdf (Page 14)

Activating your phone

Your phone is powered by a rechargeable battery. A new

battery must be charged for 4 hours at least before being

used for the first time. It reaches its optimum capacity after a

few cycles of use.

When your battery has been discharged, the phone displays

the state (empty battery icon flashes). In this case recharge

your battery for at least 15 minutes before making any more

calls so as to avoid being cut off mid-call.

To recharge the battery:

Connect the charger to a mains socket.

Plug the end of the cable into the connector at the base of the

phone.

The phone starts to charge up, the battery charging light

flashes to indicate charging. Charging stops by itself.

Disconnect the cable.

It is possible that the battery may heat up slightly during

charging; this phenomenon is normal.

Charging the battery

WARNING

There is danger of explosion if the battery is replaced incorrectly or if it is exposed to fire.

Do not short circuit it.

The battery does not have any part that you can change.

Do not try to open the battery casing.

Use only the appropriate chargers and batteries shown in the manufacturer's catalogue.

Used batteries must be disposed of in the appropriate places.

It is advisable to remove the battery if your phone is not used for extended periods.

My-X2 English.book Page 13 Lundi, 26. mai 2003 10:45 10

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 68 69

Pas de commentaire

Sagem MYV-56 Manuel d'utilisateur Page 14