Sagem myC-1 Informations techniques télécharger pdf (Page 67)



Proc Sheet 2 02

myC-1

REMOVING / REPLACING THE CHARGER

CONNECTOR

1/2

Ref. SCT U38 SSC DTS 0016 - Index A – May 6, 2004 Page 5-26

6.43 Tools :

- A 0.6mm torx screwdriver

- Soldering iron

6.44 Preliminary operation

1. Remove the battery pack ( Proc sheet 0 01).

2. Remove the back cover ( Proc sheet 1 01).

6.45 Removal procedure :

1. Unstick the ground tape (2) of the electronic board (1)

2. Turn the electronic board (1) round to liberate it from the front cover

3. Unsolder the charger connector (2) on the electronic board (1)

4. Remove the charger connector (1)

6.46 Placement procedure :

1. Replace the charger connector (2) in its housing

2. Flux the place of the charger connector contact and solder it on the electronic board (1)

3. Position the electronic board in its housing

4. Stick the ground tape (2) on the electronic board (1) by fixing correctly on the radio shielding

Nota: If the ground tape have been damaged during operations, change automatically the LCD foam

for ESD.

6.47 Further operations :

1. Remove the back cover ( Proc sheet 1 01).

2. Remove the battery pack ( Proc sheet 0 01).

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 93 94

Pas de commentaire

Sagem myC-1 Informations techniques Page 67